D1845R1
2019-09-21 Denver Tooling Meeting

1. Agenda

1.1. Objectives

The goal of this meeting is to work on the C++ Modules Ecosystem Technical Report.

1.2. Schedule

The meeting will be held on the Saturday after CppCon, 2019-09-21.

1.3. Paper Deadline

Papers intended for discussion at this meeting should be submitted to the Tooling Study Group mailing list by 2019-09-09, 7:00AM Pacific Time. There will be no formal pre- or post-meeting mailing for this meeting.

2. Logistics

2.1. Registration

If you plan to attend the meeting, please register here.

2.2. Venue and Hotel

The meeting will be co-located with CppCon 2019 in Denver, Colorado, USA. The venue and hotel is the Gaylord Rockies Resort and Convention Center, 6700 North Gaylord Rockies Boulevard, Aurora, 80019, Colorado, USA. For more information, see CppCon’s lodging page.

We recommend that attendees stay at the Gaylord Rockies; there are no other hotels within walking distance. A special room rate of $249 USD + 15.25% tax is available for attendees. Breakfast and parking are not included; parking is $29 USD a night. If you have difficulty booking a room, contact Karen Krueger.

2.3. Travel and Transportation

Attendees travelling by air should plan to fly into the Denver International Airport (DEN), which is a large international airport.

The venue is 6.3 miles (10.1 kilometers) from the Denver International Airport. There are multiple ways to get from the airport to the venue:

• Taxi service and ride shares are ~$20 USD one way.

• The venue runs a free shuttle which picks up from the 61st and Pena stop on the airport’s transit system.

2.4. Meals and Refreshments

Breakfast is not included in the hotel room rate.

2.5. Remote Attendance

Tooling Study Group regulars are welcome to participate remotely via Zoom.

2.6. Contact Information

For any inquires please contact:

• Karen Krueger.

• Bryce Adelstein Lelbach.

• Jon Kalb.